Now that
you have your teleportation rune set up, and if you haven’t yet,
just
look at the full-page
diagram; let us go
through how to use it.
First, you need to set up your pathway, or tunnel, to the place you
want to go. Do this by extending the outer ring of energy (from your
destination) upwards to the desired location- through dimensions; so
the tunnel is actually quite short and just splices into where you
want to go.
It is time
to connect the tunnel to your means of going through it. Cause the
five elemental energies to course through the straight lines of the
rune, blending together and tying the center ring to the tunnel.
Double check this step to make sure you have a strong connection.
At this
point, you are essentially ready to teleport, but before you do this,
there is another step. You need to make a clone of your now-ready
teleportation circle and place it at your destination; right where
the tunnel connects to. Do this by simply willing another prepared
circle to appear over the tunnel connection.
The final
step is the teleportation itself. Your tunnel is ready to receive
you. Remember the large mass of energy, right under your feet? Cause
it to surge upwards; and will it as hard as you can to push you
through the tunnel, to your destination. Remember that this requires
an immense
amount of energy and will. Its focused and harnessed by using a
crystal, or gemstone.
Congratulations!
Hopefully, you have just accomplished your first teleportation! If
not, however, just go back and keep trying. This takes a lot of
practice.
Just as you
can push yourself through a dimensional tunnel; you can also pull
yourself through a dimensional tunnel. This can be done if a
teleportation circle already exists at the place you want to go.
Repeat the basic method, but this time make the tunnel extend towards
you.
When you have done this, bring the beam of propulsion energy (found
in the center ring) to you, make sure it has a firm holding on the
rune, and simply have the energy pull you along and to the location.
Don’t
have enough room to draw out the whole rune? This problem is easily
solved. Just draw the rune on a sheet of paper, and place it on the
floor in front of you. Proceed to place the energies in their
required places on the rune, and begin to connect the tunnel. When
this is done, all you have to do is stretch the tunnel itself (not
the paper representation) outwards until it has reached the desired
size, and step into it. You now have your appropriately sized
teleportation circle.
Thanks to
SpellHawk for the idea of a teleportation rune; and to the rest of
the Casa Umbrae crowd (Caroline, Jordan, Nikola, Ben, Kio, and a few
more) for advice and getting me into magic.
For more
information on this sort of thing; register on
http://casaumbrae.2ya.com/
Or check
out Spell Hawk’s comprehensive magic and language sites:
http://moisant-webboard.tk
http://cmoisant.webs.com